Application Standards For Bearings

1. Application of bearing

With the general improvement of people's consumption capacity, the choice of means of transportation has also begun to diversify. In order to adapt to specialized production, the importance of bearings is self-evident. The economical manufacturing method obtains accurate fit, and at the same time, the lubricant is input during operation to achieve good work efficiency.

2. Bearing standard

Installed on a cast iron base plate or fixed on a part of a larger machine, it can support the stable operation of the bearing. The bearing should be in a form that can be dismantled and separated, although the cost will vary due to the need to apply some special links and some surfaces need to be processed. However, because of its standardization, it can be mass-produced, and the cost is low enough to offset those extra costs. Due to the relationship between the applied materials, for example, the bearing is made of cast iron, and the bracket is made of wrought iron, which must separate the bearing and the bracket; at the same time, the disassembled bearing can make each part a separate part, which is easy to cast, such as thick-walled bearings. It is extremely difficult to make a casting with a thin-walled bracket and a thin-walled bearing. Not only is it not easy to be accurate, but there are many fake castings. Mainly, the state has issued corresponding policies to strengthen the quality management of casting products.

The support method of the bearing of the linkage device depends on the specific situation, or it is installed on the ground base, or it is installed on the wall; 

Enterprises are more cautious about the material selection of bearings. Bearings will bear high surface pressure during operation. Therefore, the steel materials that constitute the bearing structure should be of good quality, and hard and brittle materials should be strictly screened out. In short, the application market scope of bearings is getting wider and wider under the more and more rigorous production process and management.